Absolute novice doubt – how do you hook your Velodyne to my personal individual.

Absolute novice doubt – how do you hook your Velodyne to my personal individual.


Requirement Representative

Sorry, Most probably this should actually be evident, but I am unable to sum it out – probably after examining the manual!

How do I connect my personal Yamaha RX3900 device to a Velodyne CHT-Q show subwoofer.

The subwoofer has actually stereo (l+r) stimulant (all You will find owned previously have had mono inputs) while the yamaha amp does not have a subwoofer productivity just where all of those other loudspeaker components are situated.

Regards, and make sure you overlook simple absurdity – I am sure the solution shall be clear once I recognize.



You must hook the Pre-OUT sub regarding the Yamaha to either the remaining or best route in the Velodyne

That is higher than the mid belonging to the three orange digital coaxial stimulant in the Yamaha

Edit: apologies that one’s an enter, the one you wish is a couple furthermore to the correct as you effectively determined they.


Expectations Manhood

All right, gratitude. It has been the right and left which was puzzling me.

Why does the subwoofer have remaining and correct programs?



Whether your amplifier hasn’t got a separate submarine woofer channel ie is actually HiFi maybe not an AV individual, but keeps stereo pre-outs, you could send full selection left and right channel on the submarine for all the sub to remove the LFE frequencies from.

As you have the LFE as a mono indicate you don’t have to hook up to both, although some visitors do it using a phono splitter. Many subs get one or other belonging to the right and left likewise denoted up as mono, or else you discover it the submarine guide proposes one across the other.


Expectations Manhood

Ah, ok, I think I have it.

There exists a whole lot to know on this subject matter.

Thank you for your own allow.


Traditional Representative

One final concern, looks like We need a wire with a male connector at one extreme (to plug in the Yamaha) and a simple cable on the other half (to hook up to either the kept or correct enter of the back associated with the subwoofer).

We have a few AV leads with connectors on, do I just trimmed one close down and rehearse that? They are not specially hefty assess line, just the type of line you have access to in a Maplins or Dixons. Will that become sufficient?


Typical Associate

I have attempted to connect the sub – nevertheless it ain’t functioning. Exactly what was I starting incorrect?

I got myself an RCA cable and cut-off one conclusion. Uncertain basically should utilize the middle cable, or perhaps the external cable for remaining or best, but experimented with both.

The subwoofer merely offers a consistent hum.

Then the other close is definitely plugged into the back of the RX3900 through the sub woofer connector, certainly not one over the 3 red connections, but furthermore along to the correct in the same row (notice connected).



Differentiated Manhood

I got myself an RCA line and blocked one close. Undecided if I should use center cable, and also the external wire for left or ideal, but attempted both.

The subwoofer merely has actually a steady hum.

Another ending try plugged into the back of the RX3900 into the sub woofer connector, maybe not one over the 3 tangerine connections, but even more along on the right in the same line (witness affixed).

You’ve got the wire attached to the correct terminal regarding the Yamaha however cannot hook the lowest stage RCA line to higher level audio speaker stimulant, really does their Velodyne get RCA stimulant (low/line level) ?

Using a solitary RCA – RCA cable you merely connect from the Yamahas submarine pre out (the main you are actually making use of these days) to a single of this the Velodynes low/line levels RCA stimulant

How can you send a photo of the backside from the Velodyne or provide actual model amount ?

Leave A Comment